A container of rubber hose and PVC hose is being load
The application of hydraulic pipes in lifting and lifting in the industrial and other fields is very common, which has saved a lot of burden for people’s work. What problems should you pay attention to during the use of hydraulic pipe fittings?
The sleeve type pipe joints must be strictly in accordance with the standards before installation. Since the type of the connector of the ferrule is different, in order to prevent leakage after the connection, it is necessary to ensure that the two ends of the joint are the same type of joint body. For example, one end should choose a three-way pipe joint, and the other end should also use this to ensure good airtightness. One thing to note here is that some people think that adding a sealant will make the seal better. In fact, this often leads to greater harm, once the glue is punched in and reaches the hydraulic chamber. Then the related parts may cause blockages, and the time and money required for maintenance will be more.
In the process of using hydraulic pipes, the problem that often occurs easily is air leakage. Due to problems such as stamping, it is easy to cause joint deformation. When it is no longer circular, gas will leak out. So check it often and make adjustments. The multiple disassemblies of the joint may also cause cracks. Once the problem is detected, the corresponding measures should be taken in time, otherwise, the air leakage will become more and more serious.
In addition to the problems that need to be paid attention to in the joints, there are some places where the hoses need to be taken care of, otherwise, the joints themselves will be affected if they are ok. For example, when the hose is arranged, it is necessary to avoid excessive bending. Even if it has to be bent, it cannot be bent at a small angle, because it is easy to increase the resistance, so it is necessary to use a large angle bending instead of a small angle bending. The hydraulic pipe joint standard should also take into account the connection with the pipe, and the pipe joint should be as flat as possible to increase the sealing. If the joint is in the bend of the pipe, in order to reduce air leakage, it is necessary to directly link the joint with a small straight pipe and then connect it with the elbow. With such a transition, it is possible to reduce the occurrence of air leaks. At the same time, the length of the pipe is determined, and the joint is also taken into consideration. Since different types of joints need to occupy different tube lengths, these should be counted to ensure that they are not inconvenient due to these problems during use. Learn more about the hydraulic pipe.
Related posts
