PE PA and PP corrugated hose look the same but quite different from each other
When you install a steam rubber hose, you should select proper bending amount and joint. Otherwise it will cause the steam hose and joints to be over-tightened or loose. Then it will damage the joint later.
How the bending factor affect the installation of steam rubber hose
If the amount of bending is too large, the plug and hose are too loose. Then the hose may protrude from the joint after the use under the action of oil pressure. While if the amount of bending is too small, the joint and hose are pressed too tightly. Then it will cause damage to the inner layer of the rubber tube and cause cracks. Besides, the high pressure oil will rupture on its own between the two places.
When you install the hose and rubber plug, the buckling speed can not be too slow. Because it will cause internal damage to the hose and the steel wire layer to fall off. Then it will cause the hose to be damaged in the early stages of use.
In addition, improper hose fitting design and low processing quality can also cause damage to the inner rubber. While if you choose an improper joint material, it will deform during the buckling process. Then it will affect the buckling quality and reduce the service life of the steam hose.
Related posts
